Recent content by bluecollarbill

I have a 1946 Woodie that I think would look great with a banjo wheel - but I can't recall seeing a post war car with a banjo wheel Were they no longer offered by Ford after the war ? Were there aftermarket manufacturers ? Thanks Bluecollarbill wjstanley@cox.net

Trying to verify that the grill guard for 1946 was a one piece unit with both bumperettes and the bar over the top. Does anyone have one they want to part with ? Thanks Bill Stanley wjstanley@cox.net

Looking for 1946 grill guard - one piece with both bumperettes I am at Hershey if you are here and have one give me a call - or if not at Hershey shoot me an email Thanks Bill Stanley 203-215-8585 wjstanley@cox.net

Looking for a Front Bumper Center Guard for a 1946 Ford. Best to contact me through email - wjstanley@cox.net - send pictures if possible Thanks Bill

Looking for a complete power steering set up for 1955 full size ford - currently just have manual steering so need everything = brackets - pump - pulleys - hydraulics - a complete set up. Please call or email - 203.215.8585 - wjstanley@cox.net Thanks

The temperature sender for the Y block in my '55 Fairlane is in the rear of the left head next to the last intake manifold bolt. There is a similar port in the right head in the same location that appears to have a freeze plug in it. I would like to add a mechanical temperature gauge as a belt...

Looking for a hot water heater set up for my '46 wagon. Hopefully FOMOCO with controls etc. Southwind currently installed - which I would trade or sell best contact is wjstanley@cox.net thanks

There are two dual filament bulbs with wired sockets in the kit - which I assume are for the front marker lights. There are additional pre-cut wires with terminals in the kit that probably run to the front and back of the car, along with clips and brackets apparently to secure the wires in...

I was able to pick up an NOS SXTS-B turn signal kit at Hershey for my '46 super deluxe. I am guessing that there was an installation diagram and/or instruction sheet for the dealer to use to install this kit. Any chance anyone out there might have one or could steer me towards where I might...

You were in the Chocolate Field at Hershey and had a complete fog light set up for a '46 Ford - lights, wiring, under dash switch - the works. I didn't buy it, because I thought I had a set - but the ones I have aren't correct for a '46. If you are out there and still have that set up - lets talk.

Don Thanks very much - that's exactly what I was hoping to find out ! Much appreciated.

I have one of those brass "Pyrene" type fire extinguishers with the ford logo. I was thinking it would look good mounted on the middle of the floor in the front of my '46 Woodie. The question is - what years were these installed or available as an option for Ford cars ? Is this something...

Looking for the Ford dealer installed optional turn signal kit used on late 40's and early 50's cars. It clamped onto the column and has "SXTS-B" and the Ford oval stamped on the switch housing. Feel free to send me an email at my regular email address wjstanley@cox.net

Looking for the Ford Dealer installed optional turn signal kit for late 40's and early 50's Fords and Mercury. It was stamped on the body "SXTS-B" - Trying to put turn signals on my '46 before I get clobbered making a turn. Would like to use the Ford kit rather than an aftermarket one if...