Recent content by BlockBuster

Now that I have your attention... I picked up and installed one of Mr. Rupert's Extreme Duty leakless water pumps. Its a really nice product. The recommendation is to add water pump lubricant to the water. I also have an old radiator that was flushed and pressure tested and found to have a tiny...

Thanks all. Much appreciated.

Can't remember how they came off or if it even matters, but should it be bolt, washer, clamshell, nut or bolt,clamshell, washer, nut? Thanks.

Found in the great state of Missouri!

Still searching... I've called AZ, NZ, CA chasing leads, but no luck yet. Does anyone know of someone who has one, but isn't using or maybe planned to use one but has it sitting on a shelf? All leads appreciated. Thanks!

I need to clarify...I only need the master cylinder conversion bracket and m/c for Model A transmission. I do not need any other parts. Thanks!

Looking for a good used or new model a hydraulic brake conversion kit from Dennis Cling. Apparently he no longer makes them.

Very nice car. Congratulations!

If you're using juice drum and backing plates on your A axles you need to clearance them both. Dennis Cling has a wonderful how-to packet that explains it all.

seat adjuster…but from what? Gents- This came off the bottom of an alleged '32 sedan bucket seat. I've enclosed pics, but I haven't seen this in any catalogs. Im using the seats in a '30 Coupe, but want to stay true to the correct mounting hardware. I want to say I've seen the adjuster once...

I'll measure up those keys. If the new keys are as good as it gets and I use Tom's advice, could I use a drop of Loctite to keep the key from riding up the keyway?

Gents- Thanks for all your help over the last several months. My rearend is rebuilt using Mr. Endy's disertation, my flywheel trued and installed, engine, clutch and transmission installed and I now have a roller to push around this winter. When installing one rear hub to axle, the axle...

I could still use one of these. My other is chipped and looks a little raunchy.

I found this thread while boning up on some info, but can I pose a question relating to the shim/hub/axle relationship? I just rebuilt my entire rear end with the help of Mr. Tom Endy's dissertation. However, I'm using '40 hydraulic drums and backing plates, both of which are in very good...

Yes, Brent. This helps. To find the bearing pre-load I ended up with .045" of gasket thickness. Until the above quote from Tom Endy I hadn't seen the .020-.050 figure anywhere and being a complete novice I was under the impression a pair of .010 's and a .005 was gonna get this done. A few...