Recent content by billy myers

I have a Riley two port head valves in head. Cam is in the model B block. I’m not sure what Jim told me I needed for a grind. It could be the SU1R grind. Do you have the specs on that grind appreciate your help I really do

Thank you for the update

Looking for some help to contact Jim BIERLY I haven’t been able to get a hold of him. He is grinding a cam for me. Does anyone have any information? I’ve been trying to contact him for three weeks thank you. I appreciate any help.

same deal as jack used an old copper gasket got at swap meet anneled it no problems got a total of 8.2 comp with red head an other things done u can also re use as long as u anneale it

i can do it for u dave i am in conn by bradley air port 10.00 per shoe 8608835290

shut down do to virus

292 std bore and crank complete less bell housing motor turns std flywheel been sitting

motor turns std flywheel all manifolds carb dist carb looks decent 500.00 east granby ct call billy 8608835290

frank I can restore your forks and have some all done

bend the arm on the throttle where the rod from carb to to throttle goes sometimes u have to also bend the throttle arm on carb also

permatex 2

Vaseline

da sander lock sander so it does not occellate and spins like a grinder 320 grit black then white try it been doing this since the sixtys problem solved take u no time got to use good amount of rogue and get warm

Macmaster carr for o rings graphite pump packing for needle adjuster

I have the same intake works for me