Recent content by Bill Schwartz

Hello 40 ford....I too and an 01A guy....Trying to get hold of the TUBMAN so as to purchase one of his brass connectors for my forty. Have he mailed him but no luck so far. Does he have an address and/or phone number. Thanks for any help you can provide.

Does anyone know where I might obtain the special bolt (91A-1447) and spare nut (78-1462a) for the correct truck-spare mount in 40 coupes? Please let me know or call me in Austin, Tx @ 512-413-1324. Thank you.

Need driver-side 1940-01A wiper stand in good, not pitted condition. Will purchase or trade for long-arm passenger side stand. Bill Schwartz, 512-413-1324.

Found one, thanks

Does anyone have one for sale? Drake/Mac/Dennis all 'out of stock'. Call me here in Austin: 512-263-2943. Very simple part but don't want to have to make one. Thanks, Bill

Beside the 2 bolts holding the starter, there's also a small bracket that attaches the rear of the starter to the oil pan. This will help some as far at the starter locking up, but doesn't solve the problem totally....The locked starter is a common Flathead problem.

Part 6A-18440, Fomoco Turn-indicator-Kit in original box. Green Bible applies part number to 42-48 Ford. Parts have never been removed from box so kit should be 100% complete, including 3 wrapped wiring brackets. Add $10 for shipping and insurance. Can call me at 512-263-2943 for any...

Looking for NOS 91A-11140, the little bracket that attaches to the back of the starter and then to the oil pan. Fell free to call me at 512-263-2943. It's for my 1940 221 cu in. Thanks for your help.

Twice since a starter rebuilt, the engine "locked-up" when engaging the starter. In some way, the starter gets in a bind with the flywheel ring gear. I "unlock it" by rocking the car back and forth while in hi-gear. Can anyone tell me what's the problem?

Does anyone know if the 'waffle-weave' tar paper used under the trunk boards is available for purchase???

Would you be interested in NOS 3-3/8 Ford 3-ring pistons that have been coated with Teflon for reduced friction and heat transfer (top). If so, email me and I'll send pictures.....schwartzzz@earthlink.net

I have a nice set of 3-ring original 3-3/8 NOS Ford pistons that have been coated with teflon for reduced friction and heat dispersal (top). Email me and I'll send you a picture. Will sell cheap. schwartzzz@earthlink.net

Does anyone know the base color for 40 Delux Mouldings? The are listed as "mahogany wood-grain", but can't find base color anywhere. Thanks

Does anyone have a roll of 1/2-inch 'Asphalt Coated Loom (conduit) used to cover headlite wiring on my 40 Ford.....Don't want the $20 "kit" that Drake sells (2 required), only the coated conduit. Can buy a 100' roll for $46, but only need 3 or so feet. Thanks for any help.