Recent content by Bill Mills

You are so right. Rear springs are as flat as a board. Are new rear springs available? Can you give me the specifics on the rear shock coil booster springs? Thanks so much for your reply.

I measured the resistance on the existing coil and it was greater than 1.5 ohms. Tech support says I do not need ballast resistor, so I left it off. Hope I did not make a mistake. Coil label says to use one. What do you think?

Removed distributor cap to see what points looked like. Broke the brittle wire from distributor to coil and from ballast resistor to coil. Replaced the distributor wire, but the terminal lug just spun in the distributor and let the new wire ground out against the side of the distributor. No...

Front suspension on my new to me 57 fairlane 500 has the front end higher than the rear. Someone probably put in wrong springs when they rebuilt front end. So, what do you suggest I do to lower it bout 3 inches? Regards, Bill

Curved stainless body side moulding/trim under passenger windows on a 2 door post. Bout 14" long and curved. Thanks so much. Bill