Recent content by Big Iron

Can a fiber timing gear loose a couple teeth and the car still run. I went to start my 29AA to go to the Pacific Mo car show Saturday and it would not fire. I cleaned the points off and it started up. When i advanced the spark lever about half way down it would start to run bad. If i pushed the...

Chris I think it would work good. You will need to put some cascade dish washing soap in first to get all of the grease out first. grease will mess with the evaporust. I filled my block with it and it seemed to work good. It will take about 3 gals to do the whole engine. Get all the grease out...

I have a AA truck. It has a mat on the floor. I mounted the switch to the cross member with a bracket I made. I took off the switch handle and made a sleeve with two set screws in it. I put a six point socket in one end and put the other end on the switch. I drilled a hole in the floor for the...

I have an early 30 with a high speed worm. It likes to run at 32 to 38 mph. You can tell what it likes by the sound. I run it up to about 40 quite I bit but only when I have to. It will do 47 or so but that is pushing it to hard.

My early 30 AA truck came with an hollow center hinge rod. It has a seam the length of it. I took a cotton rope and soaked it in chainsaw bar oil and puled it into the hollow rod. It seems to wick out of the seam and keep it lubed. The smaller side hinges I used a stainless steal rod and put...

Onlybackroads Do you have the high speed worm or the low speed rear end. I have an extra low speed. if you have a high speed we could trade.