Recent content by Autodave

Looking for a ignition switch lever and the steering lock barrel for a 35-36 column drop, Thanks

I'm looking for a Right lower cowl side 2 bolt door hinge for a 1930 Roadster. Thanks

I'm looking for a book that will guide me through reassembling a complete motor from a short block, would this be a good book for me to buy?

Looking for a 33-39 column tube only. Thanks

I use it in my occupation (collision repair on late model vehicles), primarily for door skins, roof panels and small sections of quarter panels. I only use it where the manufacture uses it, and they don't use it that much. It should be used where the two pieces of metal will lay flat, like a...

Tom, you are correct (good eye!) they are both there. I just never looked hard enough. Thanks for all of the replies, I am learning a lot.

It is fairly rough, about 2 3/4 in length. It does not have a star or anything else.

Thanks 160B, I was thinking the same thing.

Yes, it matches my engine number. Now I am wondering how long ago it was added. I has a lot of patina and they used similar rivets.

I was reading a post on the HAMB about data plates and someone commented that there was never a serial number plate put on the body. Is this correct? I have this on my 30:

I also enjoy woodworking. Now that I move my roadster out of my woodshop, I can get back to doing some. Here are a few pieces I've done:

I have found the parts, Thanks to those that responded.

Looking for 1932 bearing retainer plate (part #5099). Also 1935-36 clutch release arm (part #7511). Thanks

I am looking for closed drive parts, mainshaft, bearing retainer, and u-joint assembly. I have a open drive trans and I want to convert it to a closed drive trans. Thanks

Thanks, I found that thread...Got it narrowed down to 1940 Ford