Recent content by Augiep9

Next spot is at your best friends house

Not quite as fancy but got a silo!

That's what I was thinking also. Looks like lowering the rear is not going to be a good idea

Here she is with the 17" wires. Hubcaps should be in later this week

Thanks for the information. I did build a spring spreader last week out of 2x2 square tube and round bar. When I get around to getting the spring installed I will post more.

I'm thinking the what I am going to get is a model t reversed eye spring from speedway. I will Probly not take any leafs out and see how it sits. Here is a picture of the 33-34 wire mocked up.

I would like to get it down 3 or 4 inches in the back. The front springs seems to b sagging lower than factory already and I am put 17" wire wheels with a 5.50x17 tire. Just looking to get the gap between the fender smaller. Would a model t spring with a leaf or two removed get me low enough?

Jim huseby, where do you live? And would you by any chance have a spring spreader?

Thanks guys. So should I take the spring put to do it or is it safe to leave it in? I can weld up a spreader if need b but it's I can do it in the truck I will

How would I vow out taking some leafs out of my rear leaf pack? Put the frame of jack stands, unbolt u bolts that hold spring to crossmember, lower rear end with spring pack down, use c-clamp and all thread to get springs apart, remove the leafs and reassemble in reverse order? Does that sounds...