Recent content by Ashley

Take a look at the picture, tudor, thanks for help.

Thanks for all the help. The carb was letting gas for the sediment leak. I installed a gas line shut off and the problem stoped. One would think the needle value would have held a small weep. Thanks George

Carburetor weeping from behind data plate and throat. I have gotten sediment bowel leak down to less than a teaspoon in a 24 hr period. Have cleaned carb and had tank cleaned and sealed. The neddle and seat have been replaced and have sealed seat threads. Have checked float for leak and set...

Thanks for the information and pictures. I had removed the engine to repair the mag and needed help installing starter cable in the correct location. Thanks again, George

Is the starter cable on 1926 tudor routed down the frame and under the hogdhead or over the frame near the firewall. Along the frame under the hogshead does not appear to leave enough cable to reach the starter bolt. Thanks George

Removed engine which turned out to be quite a job. Wooden blocks on engine frame mounts turned sideways while removing and placed a bind on removal. Clearing pedals was also no fun. Hope reinstalling engine goes easier. There must a short cut to placing blocks and bolts in frame. Now on to...

Here is an update on metal in hogs head. Today turned engine with crank and shining a light through starter hold found magneto screw broken flush with flywheel. The spool is missing and screw was laying near stater housing. Still missing are some of magneto clamp and spool. Too many parts...

When changing oil a piece of metal was found in hogs head . I removed the starter and was able to remove the metal (part?) with a magnet. The starter drive cover had a small brass screw head in housing found in rear . Could this be a magneto clamp and screw? The car was running great on battery...

Looking for a Fefferson 2865 stop light lens. This lens is for a 1926 T. The lens is red glass which is mounted in a drum style stop light. The housing is 4 1/4 inches wide and 2 inches in depth. The top has STOP and bottom a tag light. Thanks, George

The stop light housing is 4and 1/4 inches side to side(top to bottom) and 2 inches depth. It has a metal stop inside on top with tag light below. The lens was red glass with slots on each side held by two screws on out side cover. Thanks for your replay. George

In need of a Jefferson 2865 tail light lens for a 1926 Model t. The lens is solid red and fits a drum tail light housing. Thanks, George