Recent content by Aquaroscoe

  1. A

    Heater motor for parts?

    Dave , I managed to get the Napa 12 v to fit my heater box by extending the sheet metal case by the 1/4" , looks fine. Easy to do
  2. A

    1939 Ford deluxe headlight rings

    Agree with the rest above, but if you want to use them you can make them work. There really is only 2 mounting points the top and the bottom. The side points seem to be for alignment only. On the top piece, you can add washers between the housing at the mount to bring it out more, ultimately the...
  3. A

    Front seat stands? 39 Ford deluxe Tudoor?

    Any way you can post a picture? I think my conv't and the tudoor share the same seat. My seat has rails that go between the seat frame and the feet. The rails are perpendicular to the floor and that is why I don't picture how yours are mounting at the rear. The seat feet are just right 90'...
  4. A

    1939 Ford 4 Door Convertible

    Hard piece to find, I suspect you will pay about $150 for each if you find them
  5. A

    39 pickup heaters

    I don't have mine in front of me, but I would think it is the middle picture, right hand side version. The inlet/outlet tubes are nearest to the defroster hoses, keeping everything up high. Did you match the mounting holes to the template on Mac Vanpelts site? Mine (coupe) isn't as tight at the...
  6. A

    Redneck...aka Ken Stewart

    It is your actions, not your words that define you. Nice gesture, excellent tribute dedication
  7. A

    What's wrong with this 39 Deluxe hood?

    any more pictures? is possible to loosen the front fenders & skirts and pull the whole assy forward? as this would bring the grill forward also.
  8. A

    39 sedan front disc brake or not?

    On the ECI 1940 setup, the hubs are kicked out about 1/2" on each side.
  9. A

    40 wagon antenna question

    Do you have the interior "C" clip installed? Because the antenna aligns based on the chrome bumps in the antenna, and the plastic holder that goes through the car. The "C" clamps put pressure on everything to keep if from moving easily
  10. A

    Door lock cylinder

    my square shaft has a hole in the center, so I just use a wire to align the square shaft as I am inserting it
  11. A

    Can't find one of these, 34 rumble hinge arm for spring

    Try Sacramento vintage ford part number 06474 2003Vp253 http://www.vintageford.com/sect_search.cfm?Line=V-8&Category=Rumble%20Seat
  12. A

    1939 top loader transmission

    Ford flathead transmission, Recently rebuilt. w/syncro's top shifter, used in a 1939 car with 8BA block Prefer not to ship
  13. A

    Columbia Rear End & controls

    1939 Columbia Rear end with controls and speedometer adapter . I believe this fits years 1935, 1946, 1937, 1938, 1939, 1940. Rear end has been bulletproofed, Includes setup for 1940 brakes/drums. I think speedometer adapter is for a 1939, the controller is for a 1940 Prefer not to ship
  14. A

    Barn find 1940 ford conv. Value

    Repectfully, I think $20K is a little high but you may be able to find someone, I think $14K to $17K is the range based on the condition described. There are a lot of specialized parts on a conv't, so that will swing the numbers if they are there.
  15. A

    39 conv hinge to door fasteners

    Mine are screwed in with allen head screws. I know the screws are not original, but I think the threaded portion is.
See more
Back
Top