Recent content by APH48

Thanks Charlville for the information.

Hello Forum members. Can someone tell me how the backseat cushion on a 30-31 Model A Ford coupe (45B) is connected to the back side of the seat? Does it connect to the package tray? How do you remove the backseat cushion? I can't seem to remove it. No problem removing the lower seat cushion...

1930artdeco, Mike, thanks for your input.

I think the routing on a coupe is different than the sedan, but I'm not sure of the order of installation of the windshield hinges. What goes on first to install this? The hinge, the vacuum line clips, or the hinge weather strip? Thanks for your input 1930artdeco.

Can anyone tell me the procedure to install the vacuum wiper line from the inside firewall to the windshield wiper motor on a 1931 (B45) coupe. I bought a new vacuum line and it has a short 90 degree on one end and the rest is straight. Also where do the vacuum line clips secure to at the...

I agree with ericr! I was able to bend the bail enough to get it to latch on the body of the light switch housing. Bob C, thanks for your idea. And thanks for everyone's help!

Hi Bob C, I have a new bail that's straight and has no slight V shape in it. Should I put a deeper V in my bail? Thanks.

Just an update. So far light switch is connected and installed in the steering column. I have a new problem, I can't get the Bail to stay in place, slight vibration causes the bail to release and light switch to fall out. Can someone help me with a cure? Thanks, Tony.

Thank you John Charlton and L T K. Your suggestions did the trick. I guess WMSW and others have experienced this problem. You guys are great, thanks.

Bob, thanks for the tip and pictures. My light switch is in the off position. My problem is the neck of the light switch body will not go in more than 1/4" into the steering gear light switch bracket. Any other ideas are welcome!

Any ideas on how to solve this problem? I'm having trouble connecting the light switch body to the steering gear light switch bracket. The light switch body only goes in about a 1/4" into the steering gear light switch bracket, so it isn't far enough to connect to the light switch spider. The...

Marshall, thanks for your suggestion. Once I saw that the mast jacket wasn't properly seated, I was able to get it in place and all is good! Thanks for the detailed description of how to solve this problem. Thanks, Tony

To all. Can anyone tell me how the cowl lamp crossover wiring is fed from the inside firewall to the cowl wire from the main light harness. Thanks to all.

Thanks to all. I took all your advice and all works well.

Greetings, can anyone tell me how to install a steering wheel all the way on the steering shaft? I can only get it in a few turns on the hex nut not, allowing the light /horn shaft to set in fully place. Thanks to all that can help.