Recent content by anothercarguy

Found a set! Yay.

I'm looking for the left side stainless steel hood trim for a '38 Ford Deluxe. Anybody out there have one their willing to part with...or have a lead? Thanks, Tim I've attached a photo...it's the mirror image of the one that is third from the right side in the photo.

Sold

That's my solution too! Your quick access to the old photo was perfect.:cool:

Sold

Thanks guys...makes sense. And Tom, your comment about limited access is exactly right! That's why I figured there had to be a clip, or as it turns out a procedure to make them work. I really appreciate the responses.

Thanks Boxcar Tom...that is very helpful. What holds them in place before the screw through the dash goes through it? Is there a spring clip or something? Or do they literally need to be held up by hand (or tape?) while feeding the dash screw into them?

Looking for some help on what the fasteners and/or clips? cage nuts? or whatever is supposed to retain the dash at the bottom of the windshield frame flange on the '32 3-windows. There are 7 recesses in the cowl area of the body (see pic) that line up with the dash holes (the screws go in from...

Thank you for that...indeed, once I get the top and frame installed, adjusted etc. this will prove quite helpful I'm sure.

Wow...thanks...that's the most convertible top info I've seen so far. i appreciate your effort!

Thanks, sounds like this is not what I'm looking for.

Hi all, I'm not real active on the Ford Barn but you guys have answered some of my previous questions (and thanks, again for that)(I'm more active on the HAMB). That said, I've got a couple questions for you. I'm potentially interested in the following book from the Ford V8 club...

Thank you very much...very helpful and appreciated!

Hi all, Wondering if someone with a '38 Ford Deluxe might be able to measure the total width from outside drivers to outside passengers side front fenders at the top of the wheel arch for me. I've included a poor quality sketch to help clarify what I'm needing just in case it's not apparent...

I am not aware that any of the head bolts go into any of the oil galleries? Am I missing something? I believe that I was drawing a small amount of coolant into the combustion chamber (as could be seen by the small areas of steam cleaned piston tops and head areas), and more so pushing...