Recent content by Al Bass

this is my visor on a 31 tudor

no drilling, cutting, or welding

I dont remember were I found these pictures but thought you would like to see them. to bad the manifold is upside down in two of the pictures. wonder if there is a car to go with the engine ?

some pictures of my bad pulley. 1st picture set to zero, no wear on shaft at oil seal and a slight nick on pulley spokes. 2nd picture shows wear on shaft from oil seal and larger nicks in pulley spokes

I put a new pulley on my engine when I rebuilt it and I ended up with a bad oil leak, the pulley wasnt machined correctly and had a wobble to it

I second the 3M 5200. I've used it to seal windshields and rear windows on older cars and the top material on on my 31 Tudor.

I used 3M 5200 (small tube) around edge of material and over tack heads, it is flat black and takes 7 days to cure but remains plyable, and Ive used it to seal windshield rubber on my 64 pv544

this is my setup.

some pic,s

monroe # 31069

Amazing what a little paint will do :)

my "A" had whitewalls when I brought her home. They were on the inside :confused::p

I've got 4 Bools on my car. They were on it when I bought it

I think I'm going to keep it (SERIOUS !!)

I found this map at the dump when I was a kid. It opens up to 16feet long. the front side follows US 99 from the Canadian border down to the Mexican border and the back side highlites the towns with pictures. just a few pictures here to give an idea of what it is.