Recent content by akmarty

  1. A

    Bob Drake Ford Carbs

    Is there a # for Charlie I need a float?
  2. A

    Need a new float

    I need a new float for my 47 ford model 59 # 94 carb any suggestions?
  3. A

    cooling and heating problem

    So an update.Figured since I have modern stats, 180 temp I bench tested 1 old and 1 new.Old one started opening at 145 and achieved full open at 180 new one started opening at 170 and fully open 180 O.K.Old stat is bigger physically then new one,taking up more room in the neck so I put a large...
  4. A

    cooling and heating problem

    When first starting after heat sink the heater blows hot air, but go's cold with temp ga.as I start moving so flow thru it is good
  5. A

    cooling and heating problem

    Ol Henry Both heads show same temps with ga. and lazer all thru the range,pulled them again just now,180 degrees and they are closed.Scooder #2 Thanks guys
  6. A

    cooling and heating problem

    Seems like if stats aren't staying open wouldn't that cause temp to at least stay below stat temp?To me the symptoms would point to stats not stopping flow,but I have ruled that out.Thanks for reply
  7. A

    cooling and heating problem

    I have searched for this prob. Can't find the answer.This is a 47 tudor with 59ab. stock except headers and elec fuel pump.I have a very good and clear rad and heater cores.I have good wide opening stats I tested at 180 fully open.I also have dual temp ga. and Y'd in both heads to heater.Have...
  8. A

    Steeringbox rebuild?

    Thanks for the help.I guess I'll pull it out and check it.
  9. A

    Steeringbox rebuild?

    I have such limited space(out of the cold) was hoping to order pts first before tying up my shop waiting for them.
  10. A

    Steeringbox rebuild?

    Yes I have, adjustment screw will turn out but not in.With wheels off the grnd and straight.
  11. A

    Steeringbox rebuild?

    Have a late 47 tudor sedan that has about 5in. of play in steering and I want to rebuild the steering.The car has all new components(tie rods.panhard bushings,kingpins,draglink). My ?, macs shows lots of parts for this yr.what do I need?17to1 15to1, all shims, gaskets ,sector,worm? This is the...
  12. A

    outside trim time

    Thanks Henry.
  13. A

    outside trim time

    Anyone have a diagram showing clip placement on chrome trim?I have a 47 tudor sedan have been working on for 2 yrs.Will be buffing out new paint this weekend.Have all the trim polished up and ready, have the complete clip kit from Macs.Is there some kind of diagram showing where wire clips...
  14. A

    Need rear splash pan side pieces 1947

    need to finish up my project these two pieces bolt to splash pan an fender.
  15. A

    This puzzle has me beat.

    Thanks again Those are hash marks on the tape.
See more
Back
Top