Recent content by Ak Sourdough

Of course it's worth dropping the pan. You've got the time, so fix it. My first post that basically said don't let an oil leak keep you home was made when I thought you wanted to make your trip this weekend. Get under there and fix the problem. These cars are simple and when they were in...

How much is it leaking? Stop and check the oil level every 10 or 15 miles until you know how often to add some and drive your car. You bought it to enjoy, so enjoy it. You might put some oil absorbent pads in a pan to shove under the car when you stop so you don't make a mess. Maybe slide...

I haven't had to do it with a Model A, but my 52 pickup had the disc rusted to the flywheel a couple times. I started it in low gear and got it going down my long driveway a few mph then held in the clutch pedal and bounced my other foot on the throttle pedal a few times to get the old truck...

That was my experience too. The Motometer is useless until the water is almost boiling and rises up in the radiator neck to touch the sensor tip. The vintage gauge in my dad's 29 Tudor read 140 most of the time. Took a few miles and a hill to get it there, but it usually stayed in about the...

https://www.fordbarn.com/forum/showthread.php?t=294531&highlight=temperature+gauge

My Coker 21" radials are substantially larger than the multiple brands of bias rags I took off. They rub just a little in a tight turn.

Tanks Inc. also has saddle tanks to fit between the running boards and the frame.

Should have started another thread.

190 is not overheated. Even plain water is fine up to boiling at 212 degrees. The problems occur when the coolant boils and creates pockets of steam where the metal temperature is momentarily much hotter than the surrounding area which causes unpredictable, uncontrolled and rapid expansion and...

Whatever it takes, it's worth it to have safety glass. To me anyway.

That looks a heck of a lot better. The terrible colorization and all the dumb horn honking was phony as a Bill Clinton 3 dollar bill. My 2 cents wont buy you much, though.

Close enough for the girls I go out with.

You're welcome Bob. Mine should be here tomorrow.

Most anyone with even moderate mechanical skills can put rings in a Model A in an afternoon, just do it. Then you'll have a new head gasket and an opportunity to tighten up the bearings a bit too.

Drill and tap a pipe thread hole in the water outlet is probably the best place.