Recent content by afuncar

  1. A

    y block ticking

    Check for rocks stuck in treads of tires.
  2. A

    Feedback on modern tube shocks for Model A's

    Installed a pair of Ken Davis shocks on the rear of my 30 roadster,they worked perfect felt the difference immediately.
  3. A

    Normal stud?

    had one with a sleeve, bugger to remove head!
  4. A

    Model A won't start

    I have had problems when my car sits usually winter to spring, most of the time I clean points and then check for spark , always worked for me.
  5. A

    Don't hammer me for asking this..

    not a drop in at all,1932 ford has a different frame.
  6. A

    Nostalgia

    oh for crying in the sink! Dirty lying dora
  7. A

    Leaky Gas Guage

    if you use any flame to repair tank make sure you clean to properly prevent possibility of explosion!
  8. A

    No more stalls at stop signs for me!

    I had a problem with stalling at stops when I searched the problem I found the gas linkage was slightly bent causing idle on high speed circuit. Bent linkage so throttle closed and engine idled on idle circuit solved problem.
  9. A

    throwout bearing Q...

    I had three different ones with three different manufacturers Germany, mexico, and U.S they all sounded dry when I spun them.I was concerned so I packed grease in from any lip and joint I could find, took a while but worked excellent.
  10. A

    Please ID these

    possibly for the brake actuator rod and cup on the end where it joins with king pin.
  11. A

    Where to start ??

    I had a bad vibration when I applied brakes,found a nut on my front spring perch under axel was loose.
  12. A

    Model A power

    You may be running too rich by opening gav too much. Half to 3/4 for start and 1/4 to run when warm some say to close when on highway.
  13. A

    Enigine work

    I,d clean it first before jumping to any conclusion. I,be seen worse clean up o.k.
  14. A

    Rear wheel lean

    worn bearing surface on bottom of axle housing,remove drum and check.
  15. A

    A or B Cam recommendation

    I used a stipe ib 330 cam works great low and high speed.
Back
Top