Recent content by abennett

  1. A

    Who knows of California Swap meets for 2014?

    June. 21 & 22 is Model T swap meet and Sept. 28 is Model A swap meet at the Little League Ball Park north of San Bernardino off I-215. Both are very good meets with lots of early Ford parts.
  2. A

    Model A Serpentine pulley system

    I have the serpentine pulley system and I LIKE it. It has cut down on vibration at all rpms and I don't have to settle that certain sweet spot in tpms. I run at any speed I want without that vibration. I feel it was money well spent.
  3. A

    600W Substitute

    Art: Aren't the differential gears helical cut?
  4. A

    600W Substitute

    Art: Explain.
  5. A

    new owner of a 31 ford

    n2oldtin Paradise Valley Model A Ford Club of San Bernardino is having a swap meet this Sunday, just down the hill from you. It is by the I-215 freeway @ the Little League ball field. This Model A Club is the nearest club to your location. Come to the meet and get acquainted with the Model A people
  6. A

    So. Cal. Swap Meet

    51st Annual Antique Car Swap Meet, Sunday Sept. 30, 2012, 6:00 am to 3:00 pm. San Bernardino,CA Western Little League Regional Headquarters, I-215 N/O San Bernardino, exit Kendall Drive. FREE admission & FREE parking. Saturday night parking available for vendors. Breakfast begins @ 6:30 - Lunch...
  7. A

    So. Cal. Swap Meet

    51st Annual Antique Car Swap Meet, Sunday, Sept. 30, 2012, 6:00 AM to 3:00 PM, FREE admission & FREE parking. Located at the Western Little League Regional Headquarters, San Bernardino, I-215 N/O San Bernardino, exit Kendall Drive. Breakfast begins @ 6:30 am - Lunch starts @ 10:00 am This meet...
  8. A

    More questions of fixing a rear main oil leak

    Al: The seal is listed for Pontiac and is smaller than the cavity that the seal goes in. I fabricated a filler from 1/4" copper tubing to take up the space needed to make the seal a proper fit to the crankshaft. Give EGGE a call, they may have a seal now that is better fit. It has been some time...
  9. A

    More questions of fixing a rear main oil leak

    Al I have had the same problem as you. B engine using the cork/neoprene seal, no leaks. I pulled all the bearing caps to check clearances when doing some other engine work and installed same seal since it still looked good. Installed engine, oil leaked. Pulled engine, seal was leaking where the...
  10. A

    model A and model B lifters

    Check out Vince Falter's website, (fordgarage.com) in the index, go down to Repo Valve Lifter. I used A lifters on a B cam and both were eaten up in 2500 miles.
  11. A

    S-10 help please

    Steve: Do you have a vent in the rear end. If the rear end is not vented, pressure will force the grease out the seal when the rear end warms up.
See more
Back
Top