Recent content by 54 Rancher

Nicely maintained 1954 Ford Milage Maker I-6 223 cubic inch engine, runs good, leaks a little oil burns very little if any oil. Complete with rebuilt starter, generator, carburator, NOS Fuel Pump, Air Cleaner, decent clutch, distributor, regulator, solenoid, Blue Diamond coil and other misc...

Nice three speed w/R10 overdrive came out of my 54 Ford Ranch Wagon. Three Speed shifts real good, OD worked most of the time. No strange noises leaked a bit. Needs gaskets. Clean inside, comes with Solenoid and Governor. FIts 49-56 Ford passenger car. Trans Jack not included Cash and local pickup

Nice set of Model A Rear Bumpers. I used these for display on a chrome plating demo. polished steel, copper, nickel, chrome. Very nice finish, some surface rust on the ends of the polished steel one. Prefer Cash and Local pick up

Need a T-85 Transmission case or whole thing if need to sell. Has side load access.

Looking for p/n b7a-6922a 57' ford r11 overdrive governor gear. Thanks, richard

I have a 57 unit and not sure how many teeth the governor should have. Currently I have a 18 tooth governor gear and I think 10 tooth worm gear on the main shaft that does not mesh. I found a 14 tooth governor gear on Ebay but has not arrived. Any help on this would be appreciated, and any...

I need a drive shaft yoke that fits a 57 or later R 11 overdrive transmission yoke. The trans/overdrive shaft has sixteen splines and measures 1.375 OD. I am not sure of the od of the yoke guess-ta-met 1 and 5/8 inch. Chevy used the same overdrive and may be the same.