Recent content by 46 ford

thank you for the good ideas, v8coopman,Rudolph, and 51504bat. I will be giving this a try

can you share the type of pcv application you used I am interested in doing the same for my 47 monarch coupe

hi Moe How did you make out with the seat covers I am also in Ontario and am looking for interior kit or good seat covers or seats for my 47 Monarch coupe look forward to your reply, Laurus

ted koudice beamsville ont advertises in old autos

I think I have a can of this as well. I can,t go any further until the seal comes in the mail, so I think i will spend Saturday at the Waterdown show and swap meet. Thanks very much to both Don and Bruce for the help. Laurus.

Ok Bruce, I used a hardwood dowel as a punch- I gave it a few taps and the zinc retainer came out easy as pie! The backside of the retainer against the flywheel was covered in oil. I am assuming that this indicates a seal failure at the mating surface of the block and the zinc retainer. I...

Bruce, thanks for the link. It was helpfull. I have defintley confimed that this zinc holder is part of my engine.I hope to try this by the end of the week and will post the outcome. Thanks again ,Laurus.

Hi bruce,this is interesting information. Tommorow evening I will have a closer look to try to identify this zinc holder.I will let you know how i make out. Thanks ,Laurus.

Yes ,my upper seal is already out. I will try itagain when the new seal comes in the mail.I appreciate the feed back and will post the results. I don't think it will be before the weekend Thanks, Laurus.

4t8v8 Thanks for the advise .i WILL TRY TYING THE CLUTCH DOWN. That sounds like a good tip. Do you think that it would be possible to loosen the center main abit and still turn the crank? Have you used the chinese pull before?

don, thanks for responding. Yes, we lubed the graphite rope seal with silicone lube as the instructions told us to. thanks laurus

hello everyone, I enjoy searching the forums for answers, but I am having trouble installing my graphite rear main seal in the engine while it is still in the truck. I removed the rear cap and was not able to pull the new seal through. I then loosened the other two mains in attempt to drop the...

P.S . email is lsinke@sympatico.ca

Ralphie, Can you post some pics. I have a 46 pickup and am interested.

Hi, I am interested . Can you send photos. Call 905 321 1078 ,lsinke@sympatico.ca