Got it this sound stupid but the inlet is the center hole correct?? And do you guys know what filters these take?? And where can I find the two seals for this canister? Thank you guys for the respond
Hey guys I need to some advice I’m trying to hook up this hildebrandt oil canister in my 8ba what step do I need to take to install it or is it a direct bolt on where the original canister is?? Thank you in advance
Hey everyone having issues on my carb it’s a 94 Holley carb Ford stamped on the body Im having issue keeping it to idle with the choke fully open if I close the choke half ways it turns on a higher idle once I start to open the choke more it dies I waited till the engine was warm and same thing...
Ok so I looked and in the back of the 39 ford cluster there is pins or anything to hook up the original ammeter I’m wondering how it works. So I checked everything had the generator rebuilt and now I’m suspecting it’s the voltage regulator what is a good way to test to to make sure I’m not just...
I have one more question I installed wires to regulator as shown and polarized it. With headlights off vehicle will stay on if I disconnect negative telling me the generator is doing something but if I turn on the headlights the engine wants to die if I disconnect the ground is that normal for 6...
Does anyone have an illustration to how to wire a flathead 8ba 6volt voltage regulator? Thank you in advance and if someone can walk me on how to polarize it.