Recent content by 36 ford vt

Thanks for the help friends! I really appreciate it. Barnfind08, can you provide info on how I can order one of these gaskets? Thanks Ron

Looking for a gasket for a 48-52 truck flywheel housing seal retainer. I’ve checked with several sources and have been told they are no longer available on the market. Vanpelt has them listed but said they are not available. Any help finding a gasket or maybe a way to fabricate one if they are...

36 Fuel ‘sender help Hello folks Trying to fix my fuel level sender on my 36. Took top off to clean the inside and points. A small brass washer fell out of the sender as shown in the photo. Not sure where this goes on the sender? Possibly in the center hole of the cover? If so, how do I...

I put the plastic Gano filters in both return hoses in my 36 ford. They are good products and were great to catch rust particles coming out of the motor before they went to the radiator. I cleaned the filters once after a few hours of operation and removed a teaspoonful of rust. I like the...

Thanks Terry, I’ll do a little tapping with my brass hammer as I work the screw. With the penetrant that may help loosen the wedge and screw also.

That sounds like a good idea. I’ll give it a try. Probably do a weeks work of penetrant first. Thanks Lawson

Thanks Johndee and Gary Johndee, I think it’s a good possibility it is a later style. I’ve had the car since 1963 so maybe that’s a good idea to look at ford wiper arms from maybe the 40s and 50s to see if I can find a match. Gary, that sounds like removing the screw is the way to remove the...

Hello Ford Barn Folks I need some help on a couple questions on my 36 Tudor touring sedan windshield wipers -photo’s attached The First question- Not sure how to remove the wiper arm from the shaft. I tried to remove the screw and it’s really stuck. Is removing this screw the way to remove...