Recent content by 35 5window

I would ask what the person is wanting and since it doesn't run thats you bargaining tool and since it needs interior thats about 4,000 plus dollars right their so if the engine is not seized up and has compression and oil and holds water in the radiator Pull one of the plugs and see if...

Great pic of how the roof soft top goes together .

Mac sells a tack strip for the door jamb B pillar and it might work. It's made of a hard rubber material and comes in two sizes and you tell them how long it needs to be and it's sold by the foot . If you can dig out a small piece and measure it for comparison you might be able to find the...

good find (Y)

Low voltage will cause it to heat up and burn out sooner if it works at all

Speedway Motors has them for fans and such for hot rods their 6 volt and good for 20/30 amps and their made by Bosch. They have a terminal for a normanly open circut and one or a normanly closed circut all on the same relay depending on how you hook it up they might work on horns too if...

could you pull the top off so we could see the gears as they do matter when buying sight un seen .

How good are the tapers and keyways where the axle goes, Ive seen many a hub that looks good on the outside but the taper are all worne out fron the key way chewing the taper out real bad ? Thanks for your reply. TOM

How good are the tapers and keyways where the axle goes, Ive seen many a hub that looks good on the outside but the taper are all worne out fron the key way chewing the taper out real bad ? Thanks for your reply. 35 5window

The pillars are replaceable but not easly because you need to jig the body before removal and install otherwise the doors wont line up correctally and welding is required at the top and rivets on the bottom sil plate. B pillars are set at the factory and can be pulled in place but then again a...

If you use the scoop style air breather use a paper filter and a screen to keep it looking original and the dirt problem wont be a problem, and I use an oil filter from a Toyota cut it apart and remove the paper element without tearing it and its about the right size and cheap too for about...

use a 35 center section and your old axle housings carriers should be the same except for the axles themselves which have a different tooth count there is always some modification to do but doable 3:25 pinions will fit 35 center section too but the pinion is cut way down on the major OD...

Try Dennis Carpenter Ford parts obsolete.!!!!

top is hot bottom is sending unit wire do not use 12 volts or you'll smoke the gauge , use a runt or something compatible that will handle the resistance full time to drop the voltage down to 6 volts thats asuming your using an original gauge

The sending units are matched to the gauge so the 35-36 gauges need the 50# sending unit and the later cars where the pressure was higher need the 80# sending unit as well as the proper gauge to read it other wise the gauge wont read correctly in either case match the sending unit to the...