Recent content by 34p-kup

Mine extend into hole 3/4", just enough to get a wood screw through the tab so they don't rattle.

I did this very swap on my '34 pick-up a LONG time ago. I had the original steering box and the f100 for fit and comparison. I remember that I milled off (I'm a machinist) part of the f100 box (disassembled) mounting flange at a slight angle. It took more than a couple of tries to get the angle...

Which size? 3/8 or 1/2"?

Hi-Country Regional Group #28 of the Early Ford V8 Club of America is very active in the Denver metro and Rocky Mtn. areas. There is a Facebook page.

Forgot, I have 12V stock type generator from mid 50's on my 8CM and didn't use relay kit.

Here's what I found, I already had halogen (no relay) dim at idle, ok at speed. While searching for relay kit on ebay, bumped into a LED conversion. Bought both. I don't remember the brand, but turns out they had the same reflectors, same pigtails. Installed LED and never looked back, just...

I also bought a spot welder from harbor freight (220v) and found that all the areas of contact need to be freshly sanded between pieces and electrodes. Clamp pressure adjustment and switch on time need to be practiced. Electrode tips also need occasional clean up too.

jimTN, the listings on bid and buy now are separated (didn't used to be) even though all listings is checked. I usually only look a day ahead on bid group, then go to bottom of page and move 3,4,5,10 pages and to find beginning of buy now group.

Received mine 1/21, Aurora, Colorado.

If it can't be fixed with a screwdriver, smash it with the hammer!

Just goy my Sept-Oct issue and read it today.

As I remember, I replaced the dash board to column bolts with Allen bolts. Easier to install I think.

Yes, moves the hood 7/8" forward. And move the radiator, hood latches won't line up, splash apron, etc. Bought one, can't use it on my p-kup. Thinking maybe it's for a firetruck, or bus.

I had the roof off of my cab last summer, same question. Friction tape was my first thought but didn't want the sticky. I ended up using fender welt, minus the bead.

Local Denver TV station aired report about theft and recovery. Very few details about recovery except it was found in a garage, little damage. Duane is very happy.