Recent content by 32truck

Re: Update Bought the ‘32!! very nice truck. Enjoy!

Awesome thanks! Sent from my SM-N986U using Tapatalk

I'm thinking about going this route. I'm not sure which pulley I can find that will work with it yet but I really like the idea of a flange that I can easily switch pulleys. I may still have to get a pulley machined anyhow though. Sent from my SM-N986U using Tapatalk

Thank you sir. I hope so too! Sent from my SM-N986U using Tapatalk

Great suggestion, but unfortunately the entire hole got wallowed out. Sent from my SM-N986U using Tapatalk

Not sure on the size of the keyway. I will measure it over the weekend. Its at my shop. Thanks. Sent from my SM-N986U using Tapatalk

Awesome info. I actually have 2 of the condensers and tried both to no avail. I really dislike the Accel coil for purely because of its size so I plan to put a new one on. Any suggestions? Sent from my SM-N986U using Tapatalk

I agree. That's the plan. Thanks for the info. Charlie should get it early next week. Sent from my SM-N986U using Tapatalk

Thanks so much. Yeah I wondered if that was vacuum that was plugged off but I'm really unfamiliar with it. I spoke with CharlieNY and sent it to him to check into it. He just recently worked on one and found issues with the plunged inside there. Sent from my SM-N986U using Tapatalk

I have about a 16th of an inch clearance with the crossmember unfortunately. Sent from my SM-N986U using Tapatalk

Definitely like this idea. Actually this makes the most sense. Definitely looking into this. Thanks so much. I agree this is a poor design. Sent from my SM-N986U using Tapatalk

Yep Shaft size is .640 Sent from my SM-N986U using Tapatalk

I've been calling around to a few machine shops without any luck yet. Sent from my SM-N986U using Tapatalk

Yeah I do have a lathe, so I was thinking about that. I don't have an end mill though. Still may attempt this. Sent from my SM-N986U using Tapatalk

No doubt! Sent from my SM-N986U using Tapatalk