Recent content by 31 RPU

  1. 3

    Metal Stem Tubes

    Where can I find six metal stem tubes for 19inch tires?
  2. 3

    Engine Stand Adapter

    Here is a store bought one I pulled out to take a photo of. I haven’t used it yet.
  3. 3

    Are you happy with your Mitchell Overdrive?

    Kinner, Did you have any problems getting the mitchell on the Vicky? Any floor board interference problems?
  4. 3

    Generator vs Alternator

    I have an alternator that looks like a generator complete with a cutout just for show. The alternator is inside a model A generator housing. Made by Russ Evans. A little pricey but well worth it.
  5. 3

    Pinion assembly installation

    Thanks Dodge.
  6. 3

    Pinion assembly installation

    Larry, Thanks for the information. I was not going to use this housing. I have a 31 rear end I was going to put the overdrive in. I appreciate the information, I didn’t know that.
  7. 3

    Pinion assembly installation

    I will need to press this pinion assembly back into the banjo. Does anyone have an old torque tube I could buy the flange off of?
  8. 3

    Pinion assembly installation

    Tom, I guess I got that one wrong. The overdrive is positioned 4.5” towards the front of the car so the stub shaft is longer. I still like the idea of a torque tube flange to do the job. So far it doesn’t look like anybody has one they would want to sell. I will hold on a little longer to see...
  9. 3

    Pinion assembly installation

    Stub shaft won’t be very long as this is in a Victoria and will be very close to the rear end. I think I will have to use all threads and nuts to draw the pinion in because the threads are very shallow for bolts. I guess I could heat it up but I liked the idea of using the flange off of a torque...
  10. 3

    Pinion assembly installation

    I made some tools like Tom Endy does his with. I am not a machinist but I am learning.
  11. 3

    Pinion assembly installation

    Thanks redmodelt but all I am doing is changing the driveshaft to install a Mitchell OD. I don’t want to disturb the pre load. All I want to do is mount the pinion assembly on the stub shaft and then press the pinion assembly/stub shaft back into the banjo. The flange off of a torque tube (like...
  12. 3

    Pinion assembly installation

    Does anyone have an old torque tube flange I could purchase to press in a pinion assembly? Picture below I borrowed from Tom Endy.
  13. 3

    1930 victoria coupe

    Ford called the Victoria’s a Coupe.
  14. 3

    Thoughts on Hershey

    Tribouboys, Sorry I missed you at Hershey. I need to talk to you about that Police Head. Check your email and private messages.
  15. 3

    Thoughts on Hershey

    Sorry I missed you at Hershey. I need to talk to you about that Police Head. Check your email and private messages.
Back
Top