Recent content by 206tee

Bob, Thanks. I'll definitely check into this. Tony

Problem Solved! It turns out that the metal dome light housing was touching the chicken wire in the roof. I put a piece of thick rubber between the dome light housing and the chicken wire and there is no more power draw when touching the power wire to the terminal box. Thanks everyone for all...

Hi guys, Thanks for all the help! Since I last posted, I went and tried a couple of things... 1. I disconnected the ground wire and when touching the power wire to the term. box, I still get a spark when the dome light switch is turned on or off. This time though, the dome light itself would...

Hi Tim, Thanks! The dome light switch itself had 2 locations to install wire, the hot wire and a second wire (Ground I assume?). I can remove the wire I am using as the ground and see if I am generating any sparks on the terminal blocks when the switch is on and off. I'll also check the...

Hi and thanks for the speedy replies! 1. The wiper cut off switch is a toggle switch that is located on a support brace where the kick panels are located. I haven't traced the wiring, but I am assuming its a standard off/on switch that he wired between the wiper motor and the terminal block...

Greetings FordBarn members, A little background first... I recently acquired a '30 Standard Coupe. The previous owner had installed an alternator on the car and had put in electric wipers on the car. The PO mentioned that when he put in the wiper motor, he had installed a 'kill' switch to...

Hi Mitch, Thanks for the picture, it really helps. Base on your description, I'll take a look/see on the door and roof wood to see if I can locate where the top rubber bumper matches up with the top of the door. If I run into any issues or problems, I'll be back. :) Thanks again!

Hi guys, I've ordered the door rubber kit shown by Marco's earlier post from Snyder's and I am not sure where the upper and lower door bumpers are located as my car does not have them on the doors. Can someone provide me a picture of their location and any tips on installing them? BTW, the...