Recent content by 1953fords

Tell pappy I'll bur the wiper arms

Having problem purchasing the correct arms for the convertible. The ones I purchased from vendors make the blades go over the stainless steel trim. Could the posts be installed incorrectly? Or do the arms differ for the convertible. I am spending a lot of money on arms that the vendors say are...

I just purchased a new battery from NAPA auto parts. It was a 7204 which is a 6 volt battery but its called a Napa commercial flooded battery 6V. Does this make a difference in my 1953 Ford Sunliner Convertible electrical system?

do you have the right and left wiper arms for 1953 Ford Sunliner Convertible?

does anyone have extra wiper arms for the 1953 ford sunliner convertible????? mine came without and they are different then the sedans reply at stastny47@yahoo.com

does anyone have extra wiper arms for the 1953 ford sunliner convertible????? mine came without and they are different then the sedans reply at stastny47@yahoo.com

does anyone have extra wiper arms for the 1953 ford sunliner convertible????? mine came without and they are different then the sedans reply at stastny47@yahoo.com

job is done and didn't even think of the 2 holes on casing of generator...someone in the early ford club told.....

thank you

I am having a problem with the generator belt...it is too close to the fan belt...I have a rebuilt generator but I need another set of eyes..............IS THERE ANYONE THAT LIVES NEAR ME THAT COULD HELP INSTALL?

Thanks to everyone who answered to my problem with the power steering. I got the control valve and piston rebuilt by Lares. I only have a small leak now at one hose connection on the piston. I tighted it as much as I could but didn't work. Is there a poundage for the connnections. I may try...

would the hoses from the control valve to the piston be the same as the cougar?

got control and piston rebuilt and now it works but hose fittings leak. where do you get new hoses?

I put a new gasket on the control valve end. Which is held with two screws. I need to know if I put the piston in the right position for the hoses from the control valve are attached correctly. Does the pistons' left side, were the hoses attach point up or down?

I installed a new piston but when I start the car the steering automatically turns the wheels to the left. What is the problem? After that happens it is locked and can't turn steering wheel. Air lock? How do you bleed the piston? Can you do it manually before starting engine. When engine...