Recent content by 1917modelt

a great deal at a swap meet

i just bought 4 brand new tires and i wont be using them for quite some time. besides keeping them tucked in a corner somewhere, what is the best way to keep them from dryrotting, cracking or whatever. would spraying them with a tire conditioner every so often help ? thanks

and a great park setting for a show

it was a great show rained in the morning, by noon the sun was out picked up some great deals

tell me how to remove the drive shaft from the banjo rear ? it appears that it has a threaded hub securing the driveshaft gear to the banjo housing ? thanks for the advice

anyone tell me where is the location of the radiator on the frame on a model A i bought a rolling chassis and i want to mount the original radiator at what point is it normally located, in inches ? hope that makes sense . thanks

can anyone tell me if the windshield frame from a model T is the same diameter on a 32 ford. on my T, i plan on adding a 4" section top and bottom on the windshield frame so it will fit nice and snug inside the A pillars. unless someone knows where i can buy that same material thats on that T...

is the bottom section of a T windshield mounted to the body, and the top section tilts outward ? i know its a dumb question

tom the spacers which would be only 1.5" would be on each end. as far as the glass being plate glass, i assume there are quite a few of T's on the road. and iam sure the glass can be replaced with newer safety glass

i have a great deal to get a model T windshield i also have a model A that iam turning into a speedster. any thoughts on mounting the T windshield on the A iam thinking of making side spacers, knowing that the length of the T windshield is shorter than the A body anyone have any thoughts. i like...

is there a common distance from the cowl, door opening area to the seat ? iam building a model A speedster, using the cowl, windshield, and dash. iam going to use a speedster bench seat. iam looking for a dimension from the windshield frame to where i should place that bench seat. hope that...

a very nice solid hood from a 1928 model A $300.00 plus shipping

pair of nice 28 model A fenders your e-mail gets pics $500.00 plus shipping

thanks to all

is it safe to assume that the driveshaft pinion gear is pressed onto the shaft itself ? i want to remove it does someone sell the tool ? thanks