Recent content by 160B

Where did your friend purchase the storage container?

deleted

Soft bonded, or hard bonded?

FYI You can get molded brake lining in soft molded, and hard molded. In my experience the soft molded has worked great with mechanical brakes and cast iron drums. I did have a set of brake shoes that were incorrectly lined with hard molded lining arched to cast iron drums and the result was poor...

The problem with a brass float is that with the tanks full the float will hit the top of the tank and make a nice little tapping noise.

Go to the MAFCA website and look at the "A" OF THE DAY and send your photo to the webmaster. Below is the link to the MAFCA website. https://www.mafca.com/index.html

Here is a link to information of The Yellowstone Trail Across Washington State http://craigmagnuson.com/yellowstone.htm

Thanks, your olive oil buddy

Here is a photo of the Kari-Keen Karrier trunk

I acquired a 1931 160B 20 plus years ago with an original top. When I acquired the vehicle the top had some cracks and leaks. I have used Dupont Thickote top dressing and sealed the top and have no leaks. This is a product from the 40's and 50's and can be found at swap meets and on e-bay. See...

On top of it all the switch is the cheap reproduction that does not have the brass bushings for the shaft to ride on!!! JUNK!!!

Engine should be fine. When you install the engine and add oil, remove the distributor and pour 1 quart of oil down the hole, this will put oil in the dipper tray so when you start the engine there will be oil for the rods.

pm sent

all of the above and new brake shoes